Does anyone know if there is a method to change an aaa configured server from failed to active?
For example I have two RSA servers configured as aaa servers on my ASA. I currently have a problem with the second one (sho aaa server shows it as failed) This isn't normally an issue expect when I reboot the main RSA server which results in the primary aaa server to go to 'failed'. I can't find any way of resetting this other than a reload.
reactivation-mode depletion deadtime 1
this command i enter it mean after one min the acs server will reactive.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...