Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

AAA Confusion

In the guide for configuring AAA it says that you must apply the access-method to the lines and interfaces, however if I use aaa authentication login it seems to apply the authentication method to all login methods anyway??

Is this becuase I am using a default method list?, and I only need to apply defined method lists to interfaces or lines? but as I dont have any the default is being used?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: AAA Confusion

When we use default it is applied to all lines. If there is no method list defined to interface default will take effect.

Regards,

~JG

3 REPLIES

Re: AAA Confusion

When we use default it is applied to all lines. If there is no method list defined to interface default will take effect.

Regards,

~JG

New Member

Re: AAA Confusion

How to define method list

New Member

Re: AAA Confusion

after the default tacacs+ local enable..etc..

150
Views
0
Helpful
3
Replies
CreatePlease to create content