Hello people, I am having some problems test AAA authenitication.
Here are the commands I have on the switch.
username cisco password cisco
aaa authentication dot1x default-local
int fa 0/3
switchport access vlan 3
after this configuration my port goes yellow obviously cos I have not entered the password. I tried to enable authentication features on the local area connection properties box on the PC but it does not prompt me to enter password after all my attempts Please does anyone have a solution for me. Thanks
to be frank, what you are doing, no one does that i.e. using routers/switch local database. I am not sure, I might have to look it up. But I dont think router/switch local database supports EAP-MD5. As far as domain goes, leave it blank when filling that information for authentication.
I would suggest if you are testing, use an ACS for Windows trial version, as a Radius server.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...