Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AAA for AT switch

The problem is authentication reporting in ACS 4.0 when user atempt to log in AT switch with AAA configured. When user is logged in switch there is no informaton about that in "Logged-in Users" report page, but when logging is failed information exists in "Failed Attempts" page. That is situation only with AT devices, not width cisco where all works good.

Does anybody have explanation for this???

2 REPLIES

Re: AAA for AT switch

This reports works on the basis of aaa accounting (start stop). Make sure you have accounting enabled on AT switch.

Regards,

~JG

Do rate helpful posts

New Member

Re: AAA for AT switch

Thank you for response, but in documentation for AT switches there is not configuration for accounting on tacacs server, only for authentication.

regards

117
Views
0
Helpful
2
Replies