I have AAA authentication/authorization setup for login into ASA9.0 firewalls.
When a user is authenticated via ASDM, its generating 20/30 lines in the log file. I have tried using radius and seem to get the same results. When login to one switch i only generate one line. Is there extra config required for ASA login or a way to prevent this
RADIUS and Symantec VIP.
I will use screenshots of ASDM, and at the end I will add the required CLI commands. the diagram below show a diagram of the steps the FW goes through when using 2FA authentication:
As you can see in Fig. 1&nbs...
Unable to get signature update from cisco.com
1. Make sure the router can get name resolution. Configure the router with a proper DNS name server.
ISR4451#utd threat-inspection signature update server cisco username xxxxx password yyyyy