Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

aaa server Failed to active on ASA

Does anyone know if there is a method to change an aaa configured server from failed to active?

For example I have two RSA servers configured as aaa servers on my ASA. I currently have a problem with the second one (sho aaa server shows it as failed) This isn't normally an issue expect when I reboot the main RSA server which results in the primary aaa server to go to 'failed'. I can't find any way of resetting this other than a reload.

1 REPLY

Re: aaa server Failed to active on ASA

Hi,

Try "reactivation-mode timed"

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/qr_711.htm#wp1644016

by default its depletion for 10 minutes.

Switching it to timed, ASA will check every 30 sec for authentication from failed server, to see if its alive.

Try this and let me know.

Regards,

Prem

2117
Views
0
Helpful
1
Replies
CreatePlease to create content