Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AAA source interface on firewall

Hi folks,

I'm setting up TACACS for the first time on a Pix 535 Firewall.  I think I have the command structure necessary as follows:

aaa-server <server group> protocol tacacs+
aaa-server <server group> host <ip> <key>
aaa authentication ssh console <server group>
aaa authentication enable console <server group>

however, what I'm not clear on is how to designate the source interface to be used...

when i run the host command, it defaults to my "inside" interface...I need to use my outside interface (T&D environment, with outside being the only interface that has connectivity to the rest of my production network, including where the ACS appliance resides).

thats the question, 1.  the command structure is correct?  and 2. how to desginate that source interface to be used.

thanks.

Bruce

1 REPLY
New Member

Re: AAA source interface on firewall

I found it...

for anybody having the same problem, i just overlooked the option when i ran the following command

aaa-server (INTERFACE) host

ooops...

thanks anyways.

Bruce

294
Views
0
Helpful
1
Replies