Access-lists and RADIUS

[pavlosd]

I would like to know if it is possible to apply dynamic access-list per user using the RADIUS protocol. To be more specific, I am trying to setup a Router as a "Proxy" telnet. A user will access the router by telnet and from there will initiate a telnet torwards another host that he is allowed.

Regards.

[nkhawaja]

Hi,

Yes Possible. See the links below

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2284/products_administration_guide_chapter09186a008015ce39.html#2006410

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800d97c1.html#1001100

I was not able to get you the exact link, but atleast it should get you started.

Thanks

Nadeem

[pavlosd]

Hello Nadeem,

Unfortunately the links you sent are under partner section and I do not have access. Can you send me some examples instead?

Regards.