11-06-2005 02:00 AM - edited 03-10-2019 02:21 PM
Hello,
Guyz, i am trying to implement ONLY accounting on PIX. The main puprose is only to log the commands/changes made on pix by users. But i am unable to find any sort of configuration which do this. i have tried capturing Telnet on local interface but it never works for PIX command logging. Can any body help here ?
Solved! Go to Solution.
11-06-2005 04:05 PM
Command Accounting only came into the PIX in the recently released v7.0, so if you're not running that then forget about trying to find it anywhere.
After upgrading to v7.0 check out the following link:
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/cref_txt/ab.htm#wp1329971
FYI, v7.0 software is available here (make sure you thoroughly read and understand the upgrade guide before doing the upgrade):
11-06-2005 04:05 PM
Command Accounting only came into the PIX in the recently released v7.0, so if you're not running that then forget about trying to find it anywhere.
After upgrading to v7.0 check out the following link:
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/cref_txt/ab.htm#wp1329971
FYI, v7.0 software is available here (make sure you thoroughly read and understand the upgrade guide before doing the upgrade):
11-06-2005 11:41 PM
Thanx :) it helped.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: