Cisco Support Community
Community Member

Acct-Terminate-Cause = none

Hi, using a Cisco 7206VXR as PDSN with IOS 12.3(4) it does send within the accounting stop packet an attribute:

Acct-Terminate-Cause = none

Since this is a non-standard, RFC value, the Radius does not send the response.

Looking in the IS-835, the PDSN should send a F13 attribute instead of the acct-terminate-cause one.

The question is how do I configure the Cisco to send F13 attribute instead of acct-terminate-cause ?.

Is there any example configuration I could use for that?

Here's my current AAA config:

aaa new-model



aaa authentication login default local

aaa authentication ppp default group radius

aaa authorization network default group radius

aaa accounting update periodic 30

aaa accounting exec default start-stop group radius

aaa accounting network default start-stop group radius

aaa accounting network pdsn start-stop group radius

aaa accounting system default start-stop group radius

aaa session-id common




radius-server host x.x.x.x auth-port 1645 acct-port 1646

radius-server timeout 20

radius-server key 7 <removed>

cdma pdsn accounting send start-stop

cdma pdsn virtual-template 1

cdma pdsn maximum sessions 511

cdma pdsn a10 max-lifetime 28800

cdma pdsn timeout a11-update 2

cdma pdsn ingress-address-filtering

cdma pdsn secure pcf default spi 100 key ascii YYY

cdma pdsn compliance is835a esn-optional

Many thanks in advance!


Re: Acct-Terminate-Cause = none

When using a Cisco IOS PDSN image, when a Mobile transitions from a active to dormant state, the corresponding Accounting-Stop record does not have a release indicator (F13) attribute

CreatePlease to create content