Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS 1111 appliance

I recently upgraded an ACS appliance 1111 from version 3.2 to 4.1.1.24. if I power up the device it asks me to reset the administrator password and all that. After the device reboots it asks me to reset the administrator password again, it keeps on doing that. And I don't have the recovery CD for the 1111. Can u assist me with finding a solution for that I will be very greatful.

2 REPLIES
Cisco Employee

Re: ACS 1111 appliance

Hi,

Make sure that you don't have any recovery CD in CD-ROM that could be a reason for getting following options:

[1] Reset administrator account

[2] Restore hard disk image from CD

[3] Exit and reboot

Enter menu item number: [ ]

In order to get recovery CD for model 1111, v4.1. You need to open a TAC case. Only TAC can publish you recovery CD's.

HTH

JK

~BR Jatin Katyal **Do rate helpful posts**
New Member

Re: ACS 1111 appliance

I have the same problem. I am using ACS 4.1.1.23

There is nothing in the cd rom drive. It reboots during the initial configuration, right after you configure the date and time.

There is another post below that mentions that the ACS cd's are specific to the hardware. How can I tell if my cd is for a 1111 or not?

thanks!

thanks!

192
Views
0
Helpful
2
Replies
CreatePlease to create content