09-22-2010 03:34 AM - edited 03-10-2019 05:25 PM
Hi,
I have an ACS 1121 appliance newly shipped and the gigabit 0 interface worked initially but after reload it didn't anymore.
Any hints?
Regards
09-22-2010 05:29 AM
Hi k abillama,
Make sure you have connected to port 6 because port 2 and 5 are the (Blocked) Gigabit Ethernet.
As you said that it worked initially but stop working after reload, it could be a hardware issue as well if the conneciton has been made as per document mentioned.
thanks,
Vinay
09-22-2010 07:12 AM
Hi vinashar,
I double checked and it's correct! During the initial setup it was working but then and after reloading the appliance it didn't work anymore. The other interface is working normally. Could it be a bug?
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: