Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

ACS 1121 Gigabit 0 not working

Hi,

I have an ACS 1121 appliance newly shipped and the gigabit 0 interface worked initially but after reload it didn't anymore.

Any hints?

Regards

2 REPLIES

Re: ACS 1121 Gigabit 0 not working

Hi k abillama,

Make sure you have connected to port 6 because port 2 and 5 are the (Blocked) Gigabit Ethernet.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/installation/guide/csacs_hw_ins.pdf

As you said that it worked initially but stop working after reload, it could be a hardware issue as well if the conneciton has been made as per document mentioned.

thanks,

Vinay

Thanks & Regards
Community Member

Re: ACS 1121 Gigabit 0 not working

Hi vinashar,

I double checked and it's correct! During the initial setup it was working but then and after reloading the appliance it didn't work anymore. The other interface is working normally. Could it be a bug?

Regards

335
Views
0
Helpful
2
Replies
CreatePlease to create content