04-11-2012 02:10 AM - edited 03-10-2019 06:59 PM
Dear Support Team
ACS 1121 Appliance has 4 Gigabit Ethernet ports on the Rear Side, They are listed as
Gigabit Ethernet 0
Gigabit Ethernet 1
Gigabit Ethernet
As per Cisco Documentation, (See Attached Snapshot), All these ports are blocked Except Gigabit Ethernet 0,
is it possible that Gigabit Ethernet 1 can be unblocked and we configure these 2 ports (Gi 0 & Gi 1) in "Teaming" so that Gi 0 connects to one Switch and Gi 1 connects to another Switch, enabling a L2 redundancy.
( if one of switch fails, ACS can still be reached via the other switch)
Thanks in Advance.
Ahad
07-24-2012 02:09 AM
Any updates to this question?
I would like to connect this device to the internet and to my LAN. How can i do this?
07-24-2012 02:48 AM
It is not supported, the code will not support nic teaming. The nics on the appliance are manufactured that way but serve no purpose. The same appliance can also be used to run the ISE software where you can use multiple interfaces but those are for other purposes.
Thanks,
Tarik Admani
*Please rate helpful posts*
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide