I have an issue with applying a patch to an ACS 1121 appliance running version 184.108.40.206. I have 5 units that needed updating and the first one is the unit with the problem. The subsequent ones updated with no issues.
When I do a show version the 220.127.116.11.10 does not show. When I try to do a reinstall I get back patch all ready exists. When I try to do an uninstall I get back patch does not exist.
Is there a command can wipe out patch 10, so I can start over? The CLI factory-reset only wipes the web configuration not the running-config or IOS.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...