Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS 3.1 VPN3000 options not displayed

I have checked the boxed to enable the display of all the VPN parameters for users and groups, but the heading diplays without any options. Is this a bug ?

TIA

Simon

2 REPLIES
Cisco Employee

Re: ACS 3.1 VPN3000 options not displayed

Make sure you've actually added a NAS in as a type Radius (VPN3000), otherwise none of the attributes will show up even though you've checked the box (although to be able to check the box you have to have added a NAS, so I'll assume you've done this :-) ).

It shows up fine on my system here, just tested it. It could be the CSAdmin service on your system has gotten screwed up, it happens sometimes. CSAdmin is the service that controls the GUI. go under Control Panel - Services and stop/start CSAdmin and see if that fixes it.

Note: don't go under System Config - Service Control within the GUI and restart the services that way, cause that restarts all the services EXCEPT CSAdmin (otherwise you'd lose your browser/GUI connection).

New Member

Re: ACS 3.1 VPN3000 options not displayed

Yes, thanks restarting CSAuth fixed it.

208
Views
0
Helpful
2
Replies
CreatePlease to create content