Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS 4.1.1.23.5 REPLICATION PROBLEMS

I upgraded two ACS SE to version 4.1.1.23.5 to solve this problem TACACS+ Command Accounting does not work.

they were working ok, but the replication between them started to fail.

these are the messages that i receive

ACS Primary: ACS 'backup' has denied replication request.

ACS Backup: Inbound database replication from ACS 'Primary' denied

please help i deeply appreciate..

7 REPLIES
Bronze

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

Do you have an entry with Self - 127.0.0.1 on any of the Servers?

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_tech_note09186a00808d9199.shtml#res

New Member

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

No, I checked the AAA Server's IP Addresses on the two servers and they've got the real ip addresses.

Any other idea??

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

Can you check that the secondary server does not have any replication mates? make sure nothing shows up in there, also double check the ip addresses and keys, make sure they are not under any NDG (network device group) and if they are make sure the shared key is the same.

New Member

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

I took off the replication partner on the secondary ACS server and the replication service works again. thanks a lot.

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

Excellent, please do rate useful posts.

New Member

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

Make sure you initiate the replication process on primary ACS server in order for the secondary ACS should get replicated.

Hope this helps

Regards

New Member

Re: ACS 4.1.1.23.5 REPLICATION PROBLEMS

Thanks for sharing this tip. I was initiating on secondary. so the bottom line is replication in ACS is is a push operation and not pull.

371
Views
10
Helpful
7
Replies