Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS 4.1 initial config

Hi,

I just pulled the 1113 out of the box and started to configure it. It seems right, but I can't access it via the web browser.

I can't do anything on the 1113 because after booting up, I get a dialog box that says "Lock Notice" use the serial port or web browser. 10.11.103.73:2002 does not work from a remote computer, and I can ping it.

The sevice csagent is running

What else can I try?

Thansk,

Randall

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: ACS 4.1 initial config

Do you have Jawa installed on the laptop. You need to install JVM for it to connect to ACS. Also check if you have multiple versions of JAWA installed uninstall all of them, reboot and install the latest JVM. I am sure it will fix the problem. I am assuming the IP address you mentioned is of the ACS.

Regards

Manoj Saxena

3 REPLIES

Re: ACS 4.1 initial config

Please follow these steps to connect.

Step 1 Connect a console to the serial console port on the back panel:

a. Attach a DB-9 to RJ-45 adapter (provided) to the serial port of the console.

b. Attach a DB-9 to RJ-45 adapter (provided) to the serial port of the Cisco Secure ACS

Solution Engine. For the location of the serial port, see Figure 1-3 on page 1-6.

c. Use an RJ-45 cable (provided) to connect the console to the Cisco Secure ACS Solution

Engine.

--------------------------------------------------------------------------------

Tip You may also use a serial concentrator connection, if desired.

--------------------------------------------------------------------------------

Step 2 Power on Cisco Secure ACS Solution Engine and the console, and open your terminal

emulation communication software on the console.

Step 3 Set your terminal emulation communication software to operate with the following

settings:

•Baud = 115200

•Databits = 8

•Parity = N

•Stops = 1

•Flow control = None

Result: The login: prompt appears.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/3.3/installation/guide/appliance/admap.html

Hope that helps

Regards,

~JG

Do rate helpful posts

New Member

Re: ACS 4.1 initial config

I did that and was sucessful in the initial config, but I cannot connect to http://10.11.103.73:2002. It is pingable

I was referring to the computer monitor with the lock notice.

Thanks,

Randall

New Member

Re: ACS 4.1 initial config

Do you have Jawa installed on the laptop. You need to install JVM for it to connect to ACS. Also check if you have multiple versions of JAWA installed uninstall all of them, reboot and install the latest JVM. I am sure it will fix the problem. I am assuming the IP address you mentioned is of the ACS.

Regards

Manoj Saxena

196
Views
0
Helpful
3
Replies
CreatePlease to create content