Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS 4.1 MAC Authentication in Network Access Profile

Im configuring Agentless Authentication based om MAC addresses sent from the access switch using MAB (MAC Authent. Bypass). I got it up and running, but with just one MAC address configured in the Authentication rule. When I try to configure more than one address in the rule, I get an error saying this is not a MAC address. How do you separate the MAC entries in the same Authentication rule. The doc says you can configure 10.000 addresses in one rule.

1 REPLY

Re: ACS 4.1 MAC Authentication in Network Access Profile

Please ensure that you are not hitting,

CSCsk27193 : Can't use while entering multiple MAC addresses

Symptom:

Pressing "return" after each MAC address yields error messages when clicking on the "Submit" button while defning authentication configuration for Network Access Profiles Access Policies.

Conditions:

This has been observed on ACS 4.1.1(23) using Internet Explorer 6.0 and JRE 1.5

Workaround:

Separate MAC addresses with a comma (,), do not press "return" after the last MAC address has been entered.

Regards,

Prem

340
Views
5
Helpful
1
Replies