Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS 4.2 HW appliance Change speed + duplex

On The ACS Hw appliance how do you configure the speed and duplex ? Currently my sw is set to 100 full and my ACS keeps on negotiating to 100 half. Any suggestions ?

1 REPLY
New Member

Re: ACS 4.2 HW appliance Change speed + duplex

Hi

Each NIC is configured to automatically detect the speed and duplex mode of the network.

Please observe the following cabling restrictions for 10BASE-T, 100BASE-TX, and 1000BASE-TX networks:

•For 10BASE-T networks, use Category 3 or greater wiring and connectors.

•For 100BASE-TX and 1000BASE-TX networks, use Category 5 or greater wiring and connectors.

•The maximum cable run length is 328 feet (ft) or 100 meters (m).

Regards

170
Views
0
Helpful
1
Replies
CreatePlease to create content