Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS 4.2, installing UDV

I am trying to install a user defined vendor data file using csutil. I can successfully install the UDV using csutil, but when I look in 'interface configuration' in ACS the new UDV is not showing. The command I am running is: 'csutil -addudv 7 symbol.ini' and it tells me it has installed successfully. I am running ACS version 4.2, here is my VSA file:

[User Defined Vendor]

Name=SYMBOL

IETF Code=388

VSA 1=SYMBOL-AUTH

[SYMBOL-AUTH]

Type=integer

Profile=out

Enums=SYMBOL-AUTH-Enums

[SYMBOL-AUTH-Enums]

1=Monitor Role

2=Helpdesk Role

4=Nwadmin Role

8=Sysadmin Role

16=WebAdmin Role

32768=Superuser Role

Can anyone shed any light on this?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ACS 4.2, installing UDV

Did you try reloading the ACS? Also first you need to add any device in network configuration using that VSA.

Now it should show up in Interface configuration.

Regards,

~JG

Do rate helpful posts

3 REPLIES

Re: ACS 4.2, installing UDV

Did you try reloading the ACS? Also first you need to add any device in network configuration using that VSA.

Now it should show up in Interface configuration.

Regards,

~JG

Do rate helpful posts

New Member

Re: ACS 4.2, installing UDV

Brilliant I can now see the VSA. I had to specifiy a device to use that VSA in network configuration before it became visible.

Many thanks for the rapid response.

Re: ACS 4.2, installing UDV

Please mark this post resolved so others can be benefit.

Regards,

~JG

246
Views
0
Helpful
3
Replies
CreatePlease login to create content