Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACS 5.1 802.1x configuration guideance

I am looking for some guidance in configuring 802.1x authentication on ACS 5.1.0.44 & Catalyst 2960S switches.

All the documents i have found seem to have incorrect screen shots or missing steps.

I am new to ACS, so don't have much experience.

I have found a doc external to Cisco

http://www.techrepublic.com/blog/networking/authenticate-users-on-the-network-by-configuring-acs-52-for-a-cisco-switch/3901

however this just hangs when attempting to complete the task in figure G.

The other docs are for configuring IBNS & assume that 802.1x is already configured.

thanks in advance

Colin

1 REPLY
Cisco Employee

ACS 5.1 802.1x configuration guideance

Hi Colin,

I hope this could help you out:

http://www.cisco.com/en/US/docs/solutions/Enterprise/Security/TrustSec_2.0/trustsec_2.0_dig.pdf

This guide refers to Cisco ISE as the authentication server.

However, its configuration could be easily "translated" into ACS 5.

The switching part stays valid.

Regards,

Fede

--

If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.

631
Views
0
Helpful
1
Replies