Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ACS 5.1 Radius

I am trying to set up user authentication against AD / Radius. Then assign either Guest user access or known user access depending on credentials.  I am encountering the following output from deb radius authentication on my switch (Cat 3750) - yet the server is reachable via ping.

00:58:28: RADIUS: Tried all servers.
00:58:28: RADIUS: No valid server found. Trying any viable server
00:58:28: RADIUS: Tried all servers.
00:58:28: RADIUS: No response from (10.254.75.124:1645,1646) for id 1645/17

could anyone help me identify where the configuration error is ?

regards

2 REPLIES
Community Member

Re: ACS 5.1 Radius

The first thing I would check is the key is the same at both ends. Also ensure that 1645 and 1646 is also configure at both ends. Lastly if you have a firewall that the appropriate rules are configured.

Jack

-


הודעה מקורית

Community Member

Re: ACS 5.1 Radius

thanks Jack - I have already checked the key - but finding my way around the

ACS 5.1 system is a bit of a minefield.....I will check the ports are correct though.

247
Views
0
Helpful
2
Replies
CreatePlease to create content