Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS 5.2 IP address of user authing

In acs, we are able to see the username and some other info about the user authing, but what I am unable to view is IP address, and mac address. Is it possible to have the wireless controller send over that info in radius and to be able to view it in acs?

Everyone's tags (3)
3 REPLIES
Cisco Employee

ACS 5.2 IP address of user authing

Did you check the same information under

Monitoring & Reports > Reports > Catalog > AAA Protocol

While you see a log entry >> click on the magnifying glass to see all the information.

Regards,

Jatin

Do rate helpful posts-

~BR Jatin Katyal **Do rate helpful posts**
New Member

ACS 5.2 IP address of user authing

In the RADIUS Authentication Detail report, MAC/IP Address is blank in the Auth Summary, and the Framed IP is blank under user.

Cisco Employee

ACS 5.2 IP address of user authing

So did you turn on the debugs on the controller to check if controller is sending the same information or not.

You may check this by enabling

debug aaa radius enable

do let me know.

Regards,

Jatin

~BR Jatin Katyal **Do rate helpful posts**
445
Views
0
Helpful
3
Replies
CreatePlease login to create content