ACS 184.108.40.206 with Bluecoat Packetshaper via Radius Auth using PAP/CHAP
We have a strange issue may be an known issue. We have the ACS 220.127.116.11 with Bluecoat Packetshaper (Packeteer) as the Radius Client and tried with PAP as well as CHAP with the suggested VSA. But once we try to authenticate with GUI in the PS end we get authentication failed. i.e its says invalid password but in the ACS end we get it as the Auth success log. We are not able to login to the PS as well. Anyone have any idea what is the issue anything to be done with the patch upgrade or any issue with the packetshaper??????
below is the logs in ACS server.
Logged At: September 4,2012 4:10:26.250 PM RADIUS Status: Authentication succeeded NAS Failure: Username: knpdtf
ACS 18.104.22.168 with Bluecoat Packetshaper via Radius Auth using PA
Do you have any special characters in the password? I would see if you can create an internal user in ACS and use a basic password (like cisco123) and see if the authentication will succeed. I have seen with some GUI based products that some special characters can cause some headaches.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...