ACS 5.3 tacacs with cisco WLC

[nir.fisher]

Hi ,

I have cisco controlles (4400,5500) and I want to use my ACS 5.3 to control management access .

I saw a document posted here for the exact same thing that I need (it clamed to work with WLC4400 and ACS5.x)

I configured the shell and all the necessary rules but It doesnt work

I have hits on the rule permitting access and in the ACS logg I am permitted but I cant seem to gain access to the controller

I have attached the related document and be happy to supply mor information

thanks

[Ven Taylor]

What exactly are you looking to do?

Are you trying to configure your wlc to authenticate admin login using TACACs+?

Ven

[Eduardo Aliaga]

Hello. I guess you saw this post https://supportforums.cisco.com/thread/217791

You have to double check if "role1" is lowercase and to delete all empty spaces when writing the value "ALL"

Please rate if it helps

[Jatin Katyal]

You can also run (Cisco Controller) >debug aaa tacacs enable  whle trying to conncet. this would actually show you if there are some extra spaces added while entering the role on ACS.

Regards,

Jatin

Do rate helpful posts-

[minkumar]

hEY

rebuild that attribute role1=ALL ,put the cursor behind the ALL and hit delete and readd it by
puuting the curson behind the ALL. That should help


Regards

Minakshi

Do rate the helpful posts!!!

[nir.fisher]

thaks everybody

I did a debug , for some reason there were spaces before "ALL" so I deleted the invisible spaces

have a good day