I'm currently in the process of reconfiguring SNS3415 single disk into 2x disk RAID1.
After adding the 2nd disk and configuring/initializing 2xdisk RAID1 through LSI RAID BIOS I went ahead with re-installation of ACS 5.4.
The ACS installation finished without a hitch.
However the SNS3415 boots up in single disk RAID 0 configuration after the install.
It seems as if the ACS install is reconfiguring the RAID setup during install and since the ACS install is non-interactive/unattended I can't tell what it's doing in the background with storage setup etc. I've repated the RAID setup and ACS install 3 times with consistant results.
Is this a normal behaviour for ACS install on SNS-3415?
Is there a way for me to breakout of 'non-interactive' install have more control over storage setup?
or is there something I'm missing to get the RAID1 working on SNS3415?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...