Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

ACS 5.5 Command Set Arguments

Ran into a small problem with ACS 5.5, when assigning Permit commands in the Command Sets I wanted to be able to Permit the "show" command with all the commands within that group being permitted. 

In ACS 4, I was able to check a small box labeled "Permit Unmatched Args" and all of the "show" commands were permitted.

Reading the guide for ACS 5 it says it uses Unix expressions for the Arguments, which I know a few, but I do not know what the "permit all" is.

 

Thanks for any help.

 

1 REPLY
Community Member

Ben,If you leave the

Ben,

If you leave the arguments blank it should have the effect you want.

cheers

Rich

201
Views
0
Helpful
1
Replies
CreatePlease to create content