Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACS 5 Radius IP Assignment

We have number of GPRS terminals, they work in our private APN. Can we assign static or dynamic IPs to them?

Terminals work with IP, not with PPP. We have direct connect with ISP via serial interface. ISP forwards all Radius traffic to our ACS appliance.

Everyone's tags (2)
4 REPLIES
Cisco Employee

ACS 5 Radius IP Assignment

You may assign a static ip address. You may try this:

~BR Jatin Katyal **Do rate helpful posts**
New Member

ACS 5 Radius IP Assignment

Thanx for reply.

I've already tried it, but it does not work. I see in ACS RADIUS Authentication Detail than appliance sent this attribute but terminal don't get it. Strange, but with ACS 3 we didn't have problems assigning static or dynamic IPs to these terminals.

Cisco Employee

ACS 5 Radius IP Assignment

What do you mean by terminals? Could you please elborate it?

Also, make sure you've radius accounting enabled on the network access device.

Regards,

Jatin

~BR Jatin Katyal **Do rate helpful posts**
New Member

ACS 5 Radius IP Assignment

Sorry for late response.

These are POS terminals, and nobody here knows how they work.

Your answer was almost right except name of attribute: giving a name Framed-IP-Address works fine.

743
Views
4
Helpful
4
Replies