Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS - Allow user to login and go straight to enable mode

I am running ACS version 3 and have several routers around the network.

I currently have it setup so tacacs is enabled and when you telnet or console into one of the routers it asks for a username and password, If the user who logins is authorised for enabled mode he can then type in enable but is it possible so when the user logs in and he is authorised for privalage commands can he go straight to enable mode without typing in enable.

Any ideas

1 REPLY
Bronze

Re: ACS - Allow user to login and go straight to enable mode

Yes this can be done.

You'll need to enable "aaa authorization exec" on the router(s), and set the privilige level in ACS to 15 in the "shell" section.

135
Views
0
Helpful
1
Replies
CreatePlease login to create content