I have authenticated cisco works with ACS as cwadmin. I am not able to view the device added through tacacs+ authentication. But the device is searchable through ip address in chasis view and am able to configure it. Please suggest a method to view the device in device management and device centre.
I have reinstalled cisco works and again added devices in acs mode. it works now. Thank you. But now the problem is it doesnot list in campus manger, or vlan port assignment. can i know any configuration is required for this?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...