Hello Everybody, I have a CISCO ACS 1113 with release 4.1.1 build 23 patch 5. I can set the IP ADDRESS using the CLI but the problem is:
1) After some time or after a reboot the appliance the IP ADDRESS is lost. In this moment the network adapter is using the default ip address 169.254.x.x or requesting a new IP by DHCP. I need a sugestion to FIX the IP on netowrk adapter in this case ?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...