Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACS appliance 3.3 - user with mulptile static IPs

Hi,

currently we are using ACS Unix. There it os possible to assign static IPs to a user based on the radius dictonary.

e.g.

NAS1- Ascent Max uses dictionary Ascend gets 10.1.1.1

NAS2- VPN 3000 uses IETF gets 10.1.2.1

Any ideas how this could be resolved on an ACS appliance?

Regards, Celio

  • AAA Identity and NAC
1 REPLY
New Member

Re: ACS appliance 3.3 - user with mulptile static IPs

Following installation and initial configuration, see the User Guide for Cisco Secure ACS Solution Engine Version 3.3 for information on how to use a browser and the HTML interface to fully configure your Cisco Secure ACS Solution Engine to provide the AAA services you want from this installation.

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_guide_chapter09186a0080235f77.html

111
Views
0
Helpful
1
Replies
This widget could not be displayed.