08-05-2008 03:10 AM - edited 03-10-2019 04:00 PM
Is it possible for me to use the two interfaces that are available on the 1113 box? I want to connect both of these interfaces to two seperate network segments. I did not find any thing specific in the Cosole except the set ip that would only config one interface.
thanks
Solved! Go to Solution.
08-05-2008 03:43 AM
You can use only one.
Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors.
For more check here
08-05-2008 03:43 AM
You can use only one.
Your Cisco 1113 system has two integrated 10/100/1000-megabit-per-second (Mbps) Ethernet connectors. ACS SE supports the operation of either Ethernet connector, but not both connectors.
For more check here
08-05-2008 03:59 AM
The Cisco Secure ACS Appliance supports the operation of only one Ethernet connector at a time. Concurrent operation of both Ethernet connectors is not supported.
Thanks,
Saravanan
08-05-2008 04:07 AM
Is there any plan for the support of the second interface in later releases? This second interface might become very usefull sometimes.
thanks
08-05-2008 09:47 AM
No. as of now there is no plan to make BOTH NIC operational at a same time.
Regards,
~JG
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: