02-01-2010 02:40 AM - edited 03-10-2019 04:55 PM
Hello,
we have an acs appliance with software 4.0. Since a couple of weeks the ethernet interface of the appliance starts to flap every minute. Neither changing the switchport nor the cable or the switch was not succesful.
Does anybody know a bug ?
Best regards
Torsten Waibel
02-01-2010 11:22 PM
Hello,
we have an acs appliance with software 4.0. Since a couple of weeks the ethernet interface of the appliance starts to flap every minute. Neither changing the switchport nor the cable or the switch was not succesful.
Does anybody know a bug ?
Best regards
Torsten Waibel
Hi Torsten,
Just try to configure a command via console toggle nic in ACS appliance and then check it happen or not.
HTH
If helpful do rate
Ganesh.H
02-03-2010 04:18 AM
Hi Ganesh,
sorry the command is not known by the windows acs appliance.
acs2> toggle nic
toggle nic: command not found.
Our hardware suppliers doesn't found any bug together with cisco.
Finally we will change the hardware.
Best regards
Torsten
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide