Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ACS authentication using AD

we are trying to set up Cisco Secure ACS (5.0) which will automatically allocate unknown users to a Guest Vlan.  802.1X is configured on the switches but our lack of undersatnding of the ACS prevents us completing this task.  I am aware that we need to configure radius even though we want Microsoft AD to do the authentication but we do not know the correct procedure - any assistance would be appreciated

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ACS authentication using AD

we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan.  802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task.  I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated

Hi,

Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!

http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml  -- 802.1x switch and ACS configuration

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html

If helpful do rate the post

Ganesh.H

1 REPLY

Re: ACS authentication using AD

we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan.  802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task.  I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated

Hi,

Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!

http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml  -- 802.1x switch and ACS configuration

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html

If helpful do rate the post

Ganesh.H

486
Views
0
Helpful
1
Replies
CreatePlease to create content