09-27-2005 03:22 AM - edited 03-10-2019 02:19 PM
Hello, The 7920 still doesn´t support EAP-FAST. So I´m wondering if it is possible to restcrict EAP-FAST users from turning LEAP on. Is there a way in ACS to do that ?
10-11-2005 04:02 AM
You can disable LEAP support on a global basis via
System COnfiguration -> Global Authentication Setup
And disable LEAP, by unchecking the LEAP checkbox
10-11-2005 05:28 AM
Thanks but I am running LEAP for the phones so I don´t whant to do that. I was wondering if this could be restricted so only 7920 phones could use LEAP but others only EAP-FAST. I cant see a way but I wanted to doublecheck if there was a solution.
11-29-2005 05:48 AM
Hi
Kristjan's question above is a good one - I'm looking for a similar answer...
I.e. can I add all my 7920 handset usernames to a group, and only allow these to do LEAP?
Also can I restrict LEAP users to a set of pre-defined MAC addresses?
Thanks
Aaron
01-25-2006 06:21 AM
Hi,
I am facing the same problem, does anyone get an answer or an idea ?
thanks
Luc
01-27-2006 09:50 AM
If you can upgrade to ACS v4.0, then you can use the Network Access Profile feature by which each specific network service can have its own authentication and authorisation policy.
If you IP phones all go into an NDG you can create a specific policy just for than NDG.
et voila!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide