I have been using Cisco ACS appliance version 4.1 and I would like to enable the SSH and SNMP monitoring .
What I have seen ,Our Cisco ACS appliance doent show the SNMP configuration option and aslo would like to enable the SSH for CLI access as our current console switch is not supporting .Please guide me how to enable SSH and SNMP features ..
Probably you have an appliance that was not re-imaged with 3.3.3 CD, where SNMP was introduced and to have SNMP option, it was necessary to re-image. And you made all the remote upgrades and reached from 3.x to version 220.127.116.11.3 on your ACS SE.
To get this option,
- Take a backup of the database
- re-image ACS SE with 4.1.1.x recovery Cd for the appropriate platform, and then upgrade it to version 4.1.4, and then apply patch 3
Re: ACS Engine /Appliance Monitoring and Management
Hi Manik, Re-imaging ACS appliance is always a last resort for the issue like this. Since we do know your ACS version should support SNMP but you could not see it in GUI, you'd better to re-image it. Re-image could fix the issue of not getting support file as well.
SSH don't give you much command to run. here is what I got
acs-1113-2> help Command Description ---------------------------------------------------- ? List commands exit Log off help List commands csdbsync -syncnow RDBMS synchronization
So basically, you can only run some RDBMS sync commands via SSH.
I do agree ..command line access will not help out more rather than basic network configuration ..but this is a only way to setup a appliance from remote location...
@ SNMP configuration ,Below are the current ACS appliance version details .base image 18.104.22.168 doesnt support SNMP features ..? what version does it support ..? plz do one favor me ...send me a link how to upgrade the base image ...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...