I have a problem with ACS, I only want to give users access to gig1/0/1 but ACS matches 1/0/10, 1/0/11, 1/0/12...1/0/19 in my command set (the statement is set to permit GigabitEthernet 1/0/1). How do I tell it to match only 1/0/1 and nothing else?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...