Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ACS Replication

I have 2 ACS boxes (Cisco Secure ACS 4.0 X solution engine 1113 appliance).Is there any way i can replicate the configuration of both the there any way or we manually need to do config replication (Both ACS reachable to each other as well as to ACS client).

Please share any document in regards with this if available and possible.

New Member

Re: ACS Replication


Thanks for the quick reply.

Actually we tried doing the replication and it was working fine.we removed the setup and shifted to diffrent location and reachability was same but we are getting the error

shared-secret mismatch

now the replication is not happening and we are surprised with this behaviour as no config change done but its just change of location (Floor shift)

Re: ACS Replication

In acs do you see 127 IP address for aaa server? Make sure shared secret is same on both ends.



Do rate helpful posts

New Member

Re: ACS Replication


Shared secrtes are same as its just change of location.

127 ip address does not exist for aaa server.

Cisco Employee

Re: ACS Replication

Sometimes its happens even though we see that shared secret keys are same and its throwing an error message "shared secret mis-match"

I would suggest you to remove and manually type shared secret again.

You may refer this:





~BR Jatin Katyal **Do rate helpful posts**
New Member

Re: ACS Replication


Thanks for the reply.

when i click for the above URL its showing==The Page You Have Requested Is Not Available

can you please attach the pdf for my reference..

CreatePlease to create content