I currently trying to set up replication between two ACS servers (installed on windows) both running software version 188.8.131.52.
The replication completes ok (as shown in the logs on both servers), but the replicated config is not showing on the secondary server.
So for example - I have 'Network Configuration Device Tables' checked on both servers (send on primary / receive on secondary), but these configured devices do no show under 'Network Configuration' when the replication has completed.
Has anyone seen this issue before? or is there something I am missing here?
Set the log level detail to full (System Configuration -> Service Control) and restart the services, then replicate again, and then look at the log files in the ACS services directories, in particular CSAuth.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...