Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS SE 4.0 - https login failed

Hi,

I have switched the ACS from http to https mode after generating a Self-Signed Certificate.

After rebooting the ACS, there is no way to connect via a webbrowser. Only the console login works.

Is there a possibility to uninstall the certificates from the console and switch back to http mode?

Best Regards

Andr?

1 REPLY
New Member

Re: ACS SE 4.0 - https login failed

Below is what you can try:

1) Restore the ACS applinace using an old backup file .

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacsapp/csapp33/install/cliap.htm

2) If you have a secondary server as well then you can re-image this ACS and replicate it with the secondary later on to the the config back. ( Note : Replication only works b/w ACS of same software version and built)

http://cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00800e518a.shtml

Thx ,

Jasjeet

144
Views
0
Helpful
1
Replies
CreatePlease to create content