On Console i m not ale to give static ip to it. As soon as the appliance reboots it enables DHCP & the configured static ip is lost. Details of Appliance is:
Cisco Secure ACS: 184.108.40.206
Appliance Management Software: 220.127.116.11
Appliance Base Image: 18.104.22.168
CSA build 22.214.171.1243.2: (Patch: 4_0_1_543)
Status: Appliance is functioning properly
Even tried to reimage the device with the recovery cd & again reconfigured the device. During that time i had provided it the tatic ip & also checked for connectivity test & it is successful. But as the device reload at the end it takes default ip add:
Appliance IP Configuration
DHCP Enabled. . . . . . . . . . .: Yes
IP Address. . . . . . . . . . . .: 169.254.11.134
Subnet Mask . . . . . . . . . . .: 255.255.0.0
After that when i login into device through console & try to provide static ip add it doesnt takes it(sometimes it takes but as soon as the device is again powered back again the static ip is lost)...
The bug CSCsm73656 was due to some issue on the hardware ACS SE 1113 (not on all ACS SE 1113, only some/few), it is not version/software specific. If your ACS SE is not losing the IP address, then you need not worry about it.
You can upgrade to version 4.1.1, then to 4.1.4 from 4.0, and ACS SE should not lose its IP address during the process.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...