Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ACS Shell Cmds stopped working

I have a group in ACS that has limited level 15 access to NDGs. Under Unmatch Commands I have "configure", with "permit terminal" under unmatched arugs. This has been working fine for months.

A week ago,this command stopped working. I've tried removing and re adding the command but no luck.

Any ideas??

This is ACS 3.3(4) on Windows platform.

1 REPLY
Community Member

Re: ACS Shell Cmds stopped working

What do does the fail attempts log say? You may also want to run "debug aaa author" and "debug tacacs author" and see what is sent and returned from ACS.

144
Views
0
Helpful
1
Replies
CreatePlease to create content