When upgrading we followed the steps outlined in the upgrade documentation and everything went fine until we did the new base image and tried to restore the 4.1.1 database. Upon restoring the database the system slowly became inoperable to the point that we had to reboot it. After re-boot the system only remained in an accessable state for about 10 minutes. We were able to go back to 3.3.3 with no problem, but we need to upgrade this system to 4.1.1. Has anyone else experienced this problem? If so did you find a solution?
I have Cisco ACS appliance 1112-K9 appliance on which ACS 3.3 is running. Since this is an appliance for which SAS is not applicable, please suggest how I can upgrade to Cisco ACS 4.0 without incurring additional cost.
How do i get entitlement for major version upgrade since there is no SAS
It might be difficult to get an answer to your question about upgrade entitlement on these lists, so the best I can personally do is to suggest that you will need to contact your Cisco Account Manager to see how the upgrade can be provided. I know this answer isn't of much use, but maybe it will provide a little direction for you.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...