Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS v5.2 - Unable to add enumeration attribute to compound condition

Hi,

     I have created an Internal User attribute and made the attribute type Enumeration so that only certain values can be selected. I am trying to apply this attribute to a compound condition. However, when I select the value of the enumerator for the compound condition none of the configured values show in the pop up window. (It is easier to explain with the screenshots.). Is there a way this can be done? Any advice would be appreciated.

Many Thanks

Dave

Enumerator Settings.JPG

Auth Polciy.JPG

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: ACS v5.2 - Unable to add enumeration attribute to compound c

I recreated your issue both in ie and firefox. I tried to remove the spaces from the enumerated strings but it didn't help

Note the enuemrated conditions do work for simple conditions. That is when in you customize the table you select CAR as a condition; rather than using a compound conditon.

I did find a CDETS for this issue:

CSCtg51846: Enum values are not shown in compound conditions in rule

2 REPLIES
Gold

Re: ACS v5.2 - Unable to add enumeration attribute to compound c

I recreated your issue both in ie and firefox. I tried to remove the spaces from the enumerated strings but it didn't help

Note the enuemrated conditions do work for simple conditions. That is when in you customize the table you select CAR as a condition; rather than using a compound conditon.

I did find a CDETS for this issue:

CSCtg51846: Enum values are not shown in compound conditions in rule

New Member

Re: ACS v5.2 - Unable to add enumeration attribute to compound c

Thanks for the reply. Hopefully this will be fixed in a new patch.

389
Views
0
Helpful
2
Replies
CreatePlease to create content