ACS v5.3 Best practices for Conditions configurations
I want to apply an authorization profile depending of the login username used, like assign the VLAN ID, so on a lab I created 2 rules, each of them using the System:Username field and then apply the Authorization profile with the correct VLAN to the user.
Which one of the following configurations will be the best practice doing this if this condition will be applied for 300 users??
Use the System:UserName condition on Identity Network Access??
Use the System:UserName condition on Authorization Network Access??
Use the System:UserName condition on Identity and Authorization Network Access??
In my opinion, the best practice will be using the System:UserName condition on Authorization Network Access but I want to know what you think, do you agree??
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...