Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

ACS Vmware - cannot ping?

I set up a trial version of an ACS server, put it in VMWare. I went through the whole set up process, ACS installed correctly but cannot ping anything from the ACS in my LAN (i chose 'bridged mode' in vmware). Is there anything else I should do? When I do 'sh run' I can see g0 with an IP address from my LAN that I assigned...

Please assist.

3 REPLIES
New Member

ACS Vmware - cannot ping?

used NAT mode in vmware... that worked...

Silver

ACS Vmware - cannot ping?

       Kindly use the VMware in NAT mode and if you are using the bridge try setting DHCP setting and so the testing by pinging to the gw.

New Member

same problemplease assist

Go to ACS and not shutdown the interface

 

 

In ACS

acs/admin#config terminal

acs/admin#interface fast0/0

acs/admin#no shutdown

310
Views
0
Helpful
3
Replies
CreatePlease to create content