Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ACS3.2 and evaluation attribute 31 (Calling Station ID)

Hi,

we are using Wireless with LEAP and what we want is, that attribute 31

is evaluate by the ACS during RADIUS ACCESS Request.

The Problem is, that I couldn’t find the attribute 31 in the ACS

Radius IETF Part.

Regards

Karlheinz

1 REPLY
Cisco Employee

Re: ACS3.2 and evaluation attribute 31 (Calling Station ID)

Accounting Attribute 31 is enabled by default on ACS. If you go to ACS; click System Configuration--> Logging --> CSV RADIUS Accounting, you will find the Calling-Station-Id.

But note that this attibute is only available supported on ISDN calls and modem calls on AS5xxx is used with PRI. See Table B-3 in URL below;

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/csnt2/ap_rads.htm

R/Yusuf

104
Views
0
Helpful
1
Replies