Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ACS5.0 and WCS

I'm trying to see if its possible to use ACS 5 patch 8 to authenticate WCS.

Looking at the ACS 5.0 gui I'm looking at where you would enter the tacacs+ or radius custom attributes. From doing some configuration it would seem that the tacacs+ custom attributes are not available but I found where you can enter the radius attributes but the cisco-av pair is a string filed that is one line and limited to 256 characters. Is anyone else trying to do this?

3 REPLIES

Re: ACS5.0 and WCS

You can not integrate WCS with ACS 5.

WCS uses HTTP service for ACS, and ACS 5 does not support this.

You need to wait for ACS 5.1

Community Member

Re: ACS5.0 and WCS

Thanks for the information. Do you have an approximate release date for ACS5.1?

Community Member

Re: ACS5.0 and WCS

Hi,

Under Shell Command Authorization mark [ciscowlc common] and [Custom attributes]

In Custum attributes apply following : role1=all

Regards Kim

458
Views
0
Helpful
3
Replies
CreatePlease to create content